FS-485G

RS232/RS485/422 high-speed light-isolated converters Manual

       FS-485G is to realize communication conversion from RS232 to RS485 and RS422. This product needs to externally connect 5V DC. There are DC / DC isolated power modules and high-speed isolated in the product to respectively realize the isolation of the power and signal. Use the unique zero-delay automatic sending and receiving conversion technique and baud rate adaptive technique. Plug-and-play, suit for all software, and in the high resistance state when not sending data.  Support multi-point communication, which is different from other similar cheap products in market. There is a built-in anti-static anti-lightning circuit in the product. Uniquely with power and sending/receiving indicator lights, the shape is the industrial structure of standard rail installation.

Technical details:

1, applies to all standard RS232 serial port, only use TXD, RXD, GND

2, output is the four-wire full-duplex RS422 interfaces and second-line half-duplex RS485 interfaces

3, need to externally connect a 5VDC, 100mA power

4, photoelectric isolated voltage: 1000VDC（up to 3000VDC，statement is needed when ordering）

5, use the shielded twisted pair whose sectional area is over 0.5 mm2 as communication lines

6, the largest communication distance is 1.8km（9.6Kbps）、1km（19.2Kbps），need TXD、RTS、DTR power supply，the greatest communication distance is no more than 100m when only TXD supply power

7, the largest number of network site is 128.

 8, the greatest communication rate is 230 Kbps, baud rate adaptive

 9, a transient voltage suppression, can withstand the transient over-voltage whose power is up to 600 W and electrostatic discharge and lighting strikes impact

10, temperature: -20 ~ 70 ℃

11, installation: installation of 35 mm standard rail and the bolt hole

12, Dimensions: 85 × 55 × 25                                                 

Products’ shape and definition of terminal signals:

Signal definition of connection terminal 

signal definition of RS232（DB9pin）socket

link of FS-485G and the RS232 interface of equipment:

     FS-485G can connect any RS232 serial interface, the RS232 socket of this product is defined by standard DTE interface. cable can be used to connect standard DCE interface. A crossover cable is needed for the DTE interface such as computer, as shown below , and this cable is incidental with the product. For other RS232 mouth witch didn’t array as standard signals, users should link sending to receiving, receiving to sending.

The application of products:

      FS-485G can be used for point-to-point communications and multi-point communications. Except for linking several other RS485/422 interfaces, it can also make as many as 128 RS232 interfaces compose of RS485 or RS422 communication network, its communication range is up to 3km（4800bps）、2km（9600bps）. The addresses of each nodes are determined by the internal procedures of the equipment. Please connect the shield to the "FG" terminal of products when using shielded twisted pair,.

1, second-line half-duplex RS485 communication network:

     Turn the RS485 and RS422 selection switch K1 of FS-485G converters to "485", the terminal resistance setting switch K2 on FS-485G of  network’s terminal and start to "R", the terminal resistance setting switch K2 on other FS-485G of the network to "OFF".

2, 4-wire full-duplex RS422 communication network

     Turn the RS485 and RS422 selection switch K1 of FS-485G converters to "422", the terminal resistance setting switch K2 on FS-485G of  network’s terminal and start to "R", the terminal resistance setting switch K2 on other FS-485G of the network to "OFF".